Author: Kathryn Adamson

Gutter Installation Tips

by Kathryn Adamson

Whether you are installing new gutters or repairing your current system, there are some key tips that will help you get the job done right. Before you start, you need to remove the old gutters and downspouts.

Gutter Installation

Whether you’re removing gutters for a repair job or for a complete replacement, you’ll want to be sure you’re doing it right. Without the proper tools and techniques, you could wind up doing more harm than good. In addition, improperly removing the old gutters can interfere with the installation of the new ones. Read on Sarasota Gutter Installation to learn more.

Remove the old gutters from the downspouts and eaves of your home. Be careful not to damage the siding, soffit, or fascia board.

Mark the downspout locations with a marker. The downspout should be at least 6 inches above the grade. In the case of a two-story house, an extension ladder is required. A ladder can also be used to attach the downspout to the drop outlet.

Pre-cut the holes for the downspouts. To do this, use a 4-inch hole saw bit. Then seal the hole with gutter sealant.

When installing the new gutters, ensure that the sections are solidly bonded together. If the brackets are in poor shape, they may fall off easily. To prevent this from happening, make sure you buy downspout connectors, which are sold at most hardware stores.

Before you begin, measure the length of the run. If your gutters are over 40 feet, you’ll need to install two downspouts at each end. You should also slope the gutters from the middle to each downspout at the end. This will ensure that rainwater flows away from the house.

During the installation of gutters, slant sections are a must to allow water to flow away from your home. The downspout is a vertical tube that hangs above the foundation of your home. If installed correctly, the downspout will carry rainwater away from your home. However, if the downspout is not installed properly, the gutter may clog and create a drainage problem.

The length of a downspout should be measured to ensure that it will fit into the gutter. This measurement is necessary to avoid causing damage to the foundation of your home.

Once you have determined the length, you need to calculate the slope of the gutter. This is called the gutter pitch. The slope is usually 5/8 of an inch. The slope should be slightly higher than the downspout.

Using a string, measure the slope of the gutter from the highest point to the lowest. Then, mark the end of the string with a pencil. Then, lower the string to the point where the downspout will be.

If the gutter is installed in a one-story house, you need to use downspout brackets. These brackets attach to the fascia of your home with heavy-duty screws.

Choosing the right size of gutters is a vital part of keeping your home safe and dry. Depending on your area’s climate, you may need to use a bigger gutter to ensure that the system can handle the heavy rainfall. If your roof is too small, runoff water may flow directly over the house, causing structural problems.

For most homes, four to six inches of gutter depth is adequate. If your roof is a steep pitch, you may need to invest in a larger gutter to keep rainwater from collecting on the roof. If you are unsure about which type of gutters is best for your home, consult a gutter installation expert for a recommendation.

The Weather Bureau has a table that will help you determine the best size for your gutters. It includes a table of rainfall intensity and the total drainage area for a particular roof shape. You can also find a table that measures the maximum rainfall over five minutes.

While measuring the length of your gutters, you should also consider the size of your downspouts. These are essentially extensions of the roof that divert water away from your home. They can be measured by climbing a ladder to the edge of the roof. They are usually about three inches wide.

Having the correct tools for the removal of nails, screws, and brackets during gutter installation is important. Having the right tools can ensure a long-lasting result. While you can remove nails and screws on your own, a professional can provide better guidance.

When it comes to the removal of nails, screws, and brackets, you should first prepare the area. This includes removing old downspouts and cleaning the gutter. You will also need to protect your roof from damage. You can use a ladder and a tarp to keep debris from entering your yard.

Stucco Repair Contractors And Why They Are A Good Idea

by Kathryn Adamson

Stucco restoration and repair are usually when the renovation of older homes has deteriorated to such an extent that repair of the stucco generally needs to be undertaken. It’s impossible to repair an already damaged stucco wall without causing extensive damage, especially with traditional home painting methods. So often, professional repair companies come up with an innovative approach to bring the old beauty back into homes. Many of these methods can be achieved with existing stucco materials.

stucco

Stucco begins to crack naturally at various points along the wall, not necessarily in areas where moisture has been a problem. These areas begin to widen after years of exposure to weather, and many times they are perfectly within the capacity of homeowners to repair with paint and stucco paint. But occasionally, cracks grow so large that a professional Stucco Repair Jacksonville FL specialists must take care of them. They can also be larger than six inches in diameter, although they often develop in those larger cracks. Small cracks can be fixed using caulk, but large cracks should be left to the professionals.

Hairline cracks are the easiest to repair, as they only need to be painted over with an overlay coat. If the damage isn’t too bad, you can sand the area down and fill it with new stucco before applying the over-scratch paint. This technique is more time-consuming, but the results look just as good. There are other types of minor stucco repairs that can be done at home. For example, if there are hairline cracks that aren’t too noticeable, you might try filling them with a colored overlay coat and then painting the exposed portion.

However, if you have large cracks that are larger than six inches in diameter, it’s advisable to hire professional stucco repair specialists to take care of the job. When you have a large crack, you can simply apply a base coat around it and then apply the repair underneath. But when you have smaller hairline cracks, you will probably have to apply several layers of repair to make sure that it’s completely covered.

There are many types of stucco repair, so it’s important to understand the different techniques before deciding which one is right for you. There are basically three different methods for fixing stucco damage. The first is called wet repair. In this process, the affected area is soaked with warm water and then repaired using a mixture of cement and sand. Once this is done, the area is allowed to dry overnight, then repositioned and allowed to dry again before covering with another layer of cement.

Another method is referred to as low maintenance or sand in, which has many advantages over the traditional stucco application. By using sand in your low maintenance stucco repair, you can easily cover small cracks while leaving the larger ones repaired. For instance, if you had a hole in your wall caused by a water leak but because you have used a mixture of cement and sand in your low maintenance repair, you can easily fill the hole and put a new panel right over top of the repair. This new panel will look just like the rest of the original wall and will last for years without needing to be repaired. This is not the case with traditional stucco installation, where repairing a single board isn’t possible unless there’s major damage to all of the panels.

Yet another type of stucco repair is referred to as flashings. Flashings are used to fix minor moisture damage to your exterior wall without having to replace the entire wall. Sometimes just sealing the leak with a silicone caulk agent will solve this problem. If you have flashings that you believe may need replacing, consult an exterior wall repair expert.

Some commercial structures may need more extensive stucco maintenance than others. Exterior walls in areas prone to rain or snow, for example, must have their cracks repaired yearly. However, those living in areas that experience little or no rain or snow may choose to have their commercial structures’ stucco maintenance performed less often, but still have their exterior walls periodically repaired to prevent unnecessary damage.